[Determination of 222 pesticide residues in olive oil by fully automatic QuEChERS pre-treatment instrument coupled with gas chromatography-quadrupole-time-of-flight mass spectrometry].

Pesticide residues may be present in olive oil because pesticides are applied to olive trees during their cultivation and growth for pest prevention and some of these pesticides are not easily degraded. Studies on pesticide residues in olive oil have mainly focused on the detection of single types of pesticide residues, and reports on the simultaneous detection of multiple pesticide residues are limited. At present, hundreds of pesticides with different polarities and chemical properties are used in practice. In this study, an analytical method based on fully automatic QuEChERS pretreatment instrument coupled with gas chromatography-quadrupole time-of-flight mass spectrometry (GC-QTOF-MS) was established for the rapid determination of 222 pesticide residues in olive oil. The effects of acetonitrile acidification concentration, n-hexane volume, oscillation time, centrifugation temperature, and purification agent on the determination of the 222 pesticide residues were investigated. First, ions with good responses and no obvious interference were selected for quantification and characterization. The purification process was then developed by setting the parameters of the fully automatic QuEChERS pretreatment instrument to optimal values. The sample was extracted with acetonitrile containing 2% formic acid, and the supernatant was purified by centrifugation in a centrifuge tube containing 400 mg N-propylethylenediamine (PSA), 400 mg octadecylsilane-bonded silica gel (C18), and 1200 mg anhydrous magnesium sulfate. The purified solution was blown dry with nitrogen and then fixed with ethyl acetate for instrumental analysis. Finally, a matrix standard solution was used for quantification. The method was validated in terms of matrix effects, linear ranges, limits of detection (LODs) and quantification (LOQs), accuracies, and precisions. The results showed that 86.04% of the 222 pesticides had linear ranges of 0.02-2.00 µg/mL, 10.81% had linear ranges of 0.10-2.00 µg/mL, and 3.15% had linear ranges of 0.20-2.00 µg/mL. The pesticide residues showed good relationships within their respective linear ranges, and the correlation coefficients (R2) were greater than 0.99. The LODs of all tested pesticides ranged from 0.002 to 0.050 mg/kg, and their LOQs ranged from 0.007 to 0.167 mg/kg. Among the 222 pesticides determined, 170 pesticides had LOQs of 0.007 mg/kg while 21 pesticides had LOQs of 0.017 mg/kg. At the three spiked levels of 0.2, 0.5, and 0.8 mg/kg, 79.58% of all tested pesticides had average recoveries of 70%-120% while 65.92% had average recoveries of 80%-110%. In addition, 93.54% of all tested pesticides had relative standard deviations (RSDs, n=6)<10% while 98.35% had RSDs (n=6)<20%. The method was applied to 14 commercially available olive oil samples, and seven pesticides were detected in the range of 0.0044-0.0490 mg/kg. The residues of fenbuconazole, chlorpyrifos, and methoprene did not exceed the maximum limits stated in GB 2763-2021. The maximum residual limits of molinate, monolinuron, benalaxyl, and thiobencarb have not been established. The method utilizes the high mass resolution capability of TOF-MS, which can improve the detection throughput while ensuring good sensitivity. In addition, high-resolution and accurate mass measurements render the screening results more reliable, which is necessary for the high-throughput detection of pesticide residues. The use of a fully automatic QuEChERS instrument in the pretreatment step reduces personnel errors and labor costs, especially when a large number of samples must be processed, thereby offering significant advantages over other approaches. Moreover, the method is simple, rapid, sensitive, highly automatable, accurate, and precise. Thus, it meets requirements for the high-throughput detection of pesticide residues in olive oil and provides a reference for the development of detection methods for pesticide residues in other types of oils as well as the automatic pretreatment of complex matrices.

[Determination of six halogenated solvent residues in olive oil by headspace gas chromatography].

The residual amount of halogenated solvents in olive oil is an important indicator of its quality. The National Olive Oil Quality Standard GB/T 23347-2021 states that the residual amount of individual halogenated solvents in olive oil should be ≤0.1 mg/kg and that the total residual amount of halogenated solvents should be ≤0.2 mg/kg. COI/T.20/Doc. No. 8-1990, which was published by the International Olive Council, describes the standard method used for the determination of halogenated solvents in olive oil. Unfortunately, this method is cumbersome, has poor repeatability and low automation, and is unsuitable for the detection and analysis of residual halogenated solvents in large quantities of olive oil. At present, no national standard method for determining residual halogenated solvents in olive oil is available in China. Thus, developing simple, efficient, accurate, and stable methods for the determination of residual halogenated solvents in olive oil is imperative. In this paper, a method based on automatic headspace gas chromatography was established for the determination of residual halogenated solvents, namely, chloroform, carbon tetrachloride, 1,1,1-trichloroethane, dibromochloromethane, tetrachloroethylene, and bromoform, in olive oil. The samples were processed as follows. After mixing, 2.00 g (accurate to 0.01 g) of the olive oil sample was added into a 20 mL headspace injection bottle and immediately sealed for headspace gas chromatography analysis. Blank virgin olive oil was used to prepare a standard working solution and the external standard method for quantification. The solvents used in the preparation of halogenated solvent standard intermediates were investigated and methanol was selected as a replacement for N,N-dimethylacetamide to prepare a halogenated solvent standard intermediate owing to its safety. The effects of different injection times (1, 2, 3, 4, 5, 6 s), equilibration temperatures (60, 70, 80, 90, 100, 110, 120 ℃), and equilibration times (4, 5, 8, 10, 20, 30, 40 min) of the headspace sampler on the detection of the residual amounts of the six halogenated solvents were investigated. The optimal injection time and equilibration temperature were 3 s and 90 ℃, respectively. The method demonstrated good analytical performance for the six halogenated solvents when the equilibration time was 30 min. A methodological study was conducted on the optimized method, and the results showed that the six halogenated solvents exhibited good linear relationships in the range of 0.002-0.200 mg/kg, with correlation coefficients of ≥0.9991. The limits of detection (LODs) and quantification (LOQs) of 1,1,1-trichloroethane and bromoform were 0.0006 and 0.002 mg/kg, respectively. The LODs and LOQs of chloroform, carbon tetrachloride, dibromochloromethane, and tetrachloroethylene were 0.0003 and 0.001 mg/kg, respectively. The average recoveries under different spiked levels were 85.53%-115.93%, and the relative standard deviations (n=6) were 1.11%-8.48%. The established method was used to analyze 13 olive oil samples available in the market. Although no halogenated solvents were detected in these samples, a limited number of samples does not represent all olive oils. Hence, monitoring residual halogenated solvents in olive oil remains necessary for its safe consumption. The LOQs of the method for the six halogenated solvents were significantly lower than that of the COI/T.20/Doc. No. 8-1990 standard method (0.02 mg/kg). In addition, the developed method can be conducted under short operation times with high precision and degree of automation as well as good accuracy. Thus, the proposed method is suitable for the determination and analysis of the residues of the six halogenated solvents in large batches of olive oil samples.

[Determination of 41 veterinary drug residues in livestock and poultry meat using a composite purification system coupled with direct analysis in real time-tandem mass spectrometry].

In a market environment where food safety problems still occur despite repeated prohibitions, food safety problems caused by veterinary drug residues and biological safety problems caused by the transfer of drug resistance have attracted much attention. Herein, a method based on a compound purification system coupled with direct analysis in real time-tandem mass spectrometry (DART-MS/MS) was established to determine 41 different types of veterinary drug residues in livestock and poultry products. First, a single-standard solution sampling method was used to optimize the selection of the best quasi-molecular ion, two daughter ions, and their cone-hole and collision voltages; qualitative and quantitative ion pairs are composed of a quasi-molecular ion and its corresponding daughter ion. The abundance ratios of the drug compounds in standard solutions of the solvent and matrix mixtures were then calculated according to the requirements of the European Union 2002/657 specification. DART-MS/MS was subsequently developed for the accurate characterization and quantitative analysis of the veterinary drugs. Finally, a composite purification pretreatment system was formed by combining the primary secondary amine (PSA) and octadecyl bonded silica gel (C18) of a QuEChERS technology with multiwalled carbon nanotubes (MWCNTs) to achieve the one-step purification of the drug compounds. The influence of the key parameters of the DART ion source on the determination of the drugs was investigated using the peak areas of the quantitative ions as the criterion. The optimum conditions were as follows: ion source temperature of 350 ℃, 12-Dip-it Samplers module, sample injection speed of 0.6 mm/s, and external vacuum pump pressure of -75 kPa. According to the differences in the dissociation constant (pKa) ranges of the 41 types of veterinary drug compounds and the characteristics of the sample matrixes, the extraction solvent, matrix-dispersing solvent, and purification method were optimized based on the recovery. The extraction solvent was 1.0% acetonitrile formate solution, and the pretreatment column included MWCNTs containing 50 mg of PSA and 50 mg of C18. The three chloramphenicol drugs showed a linear relationship in the ranges of 0.5-20 µg/L with correlation coefficients of 0.9995-0.9997,and the detection and quantification limits of three chloramphenicol drugs were 0.1 and 0.5 µg/kg, respectively. The 38 other drugs, including quinolones, sulfonamides, and nitro-imidazoles showed a linear relationship in the ranges of 2-200 µg/L with correlation coefficients of 0.9979-0.9999, and the detection and quantification limits of the 38 other drugs were 0.5 and 2.0 µg/kg, respectively. The recoveries of the 41 veterinary drugs at low, medium, and high spiked levels in chicken, pork, beef, and mutton samples were 80.0%-109.6%, with intra- and inter-day precisions of 0.3%-6.8% and 0.4%-7.0%, respectively. A total of 100 batches of animal meat (pork, chicken, beef, and mutton; 25 batches each) and known positive samples were simultaneously analyzed using the national standard method and the detection method established in this study. Sulfadiazine (89.2, 78.1, and 105.3 µg/kg) was detected in three batches of pork samples, and sarafloxacin (56.3, 102.0 µg/kg) was detected in two batches of chicken samples and no veterinary drugs were detected in the other samples; both methods yielded consistent results for known positive samples. The proposed method is rapid, simple, sensitive, environmentally friendly, and suitable for the simultaneous screening and detection of multiple veterinary drug residues in animal meat.

A self-assembled DNA nanostructure for targeted and pH-triggered drug delivery to combat doxorubicin resistance.

We developed a novel self-assembled DNA nanostructure for anticancer drug delivery. The resulting nanostructure was able to specifically target cancer cells and release the loaded drug at pH 5.0. More importantly, the drug-loaded DNA nanostructure effectively circumvented doxorubicin resistance of human lung adenocarcinoma epithelial cancer cells.

Quantitative Proteomic Analysis of Cellular Resistance to the Nanoparticle Abraxane.

Abraxane, an FDA-approved albumin-bound nanoparticle (NP) form of paclitaxel (PTX) to treat breast cancer and nonsmall cell lung cancer (NSCLC), has been demonstrated to be more effective than the original Taxol, the single molecule form. We have established a cell line from NSCLC A549 cells to be resistant to Abraxane. To further understand the molecular mechanisms involved in the NP drug resistance, global protein expression profiles of Abraxane sensitive (A549) and resistant cells (A549/Abr), along with the treatment of Abraxane, have been obtained by a quantitative proteomic approach. The most significantly differentially expressed proteins are associated with lipid metabolism, cell cycle, cytoskeleton, apoptosis pathways and processes, suggesting several mechanisms are working synergistically in A549 Abraxane-resistant cells. Overexpression of proteins in the lipid metabolism processes, such as E3 ubiquitin-protein ligase RNF139 (RNF139) and Hydroxymethylglutaryl-CoA synthase (HMGCS1), have not been reported previously in the study of paclitaxel resistance, suggesting possibly different mechanism between nanoparticle and single molecular drug resistance. In particular, RNF139 is one of the most up-regulated proteins in A549 Abraxane-resistant cell line, but remains no change when the resistant cells were further treated with Abraxane and down-regulated in the sensitive cells after 4 h treatment of Abraxane. This study shows the use of a proteomic strategy to understand the unique response of drug resistant cells to a nanoparticle therapeutic.

Abraxane, the Nanoparticle Formulation of Paclitaxel Can Induce Drug Resistance by Up-Regulation of P-gp.

P-glycoprotein (P-gp) can actively pump paclitaxel (PTX) out of cells and induces drug resistance. Abraxane, a nanoparticle (NP) formulation of PTX, has multiple clinical advantages over the single molecule form. However, it is still unclear whether Abraxane overcomes the common small molecule drug resistance problem mediated by P-gp. Here we were able to establish an Abraxane-resistant cell line from the lung adenocarcinoma cell line A549. We compared the transcriptome of A549/Abr resistant cell line to that of its parental cell line using RNA-Seq technology. Several pathways were found to be up or down regulated. Specifically, the most significantly up-regulated gene was ABCB1, which translates into P-glycoprotein. We verified the overexpression of P-glycoprotein and confirmed its function by reversing the drug resistance with P-gp inhibitor Verapamil. The results suggest that efflux pathway plays an important role in the Abraxane-resistant cell line we established. However, the relevance of this P-gp mediated Abraxane resistance in tumors of lung cancer patients remains unknown.